Troubleshooting - A Guide for Injection Molders
International Plastic Laboratories and Services
Georgetown, Texas 78633
Georgetown, Texas 78633
SPECIAL
Written by Douglas Bryce, training expert from Texas Plastic Technologies, this book offers a portable and permanent reference version of his successful troubleshooting seminar. (This book normally sells for $59 to $76, plus $5 shipping and handling.)
SPECIAL SALE!!!
Professional Quality!
This quality hardcover book is intended for operators, technicians, trainers, engineers, supervisors, and all others responsible for quickly identifying and solving process problems at the molding machine.
Readers will better understand the relationships between machine, mold, material, and operator. With this knowledge, troubleshooting becomes systematic and effective.
Full Color PHOTOS!
Following a review of the process and basic troubleshooting principles, readers are guided through 24 of the most common defects, complete with full-color photographs of each defect to help develop effective skills at quickly identifying and solving these problems.
This quality hardcover book is intended for operators, technicians, trainers, engineers, supervisors, and all others responsible for quickly identifying and solving process problems at the molding machine.
Readers will better understand the relationships between machine, mold, material, and operator. With this knowledge, troubleshooting becomes systematic and effective.
Full Color PHOTOS!
Following a review of the process and basic troubleshooting principles, readers are guided through 24 of the most common defects, complete with full-color photographs of each defect to help develop effective skills at quickly identifying and solving these problems.
$59-$76 Value
ONLY $19.95
plus s&h
ONLY $19.95
plus s&h
EVERYTHING BELOW. . . for only $19.95 plus s&h!!! A $59 value!!!
Here are the 24 defects this Book thoroughly covers:
Black Specks, Blisters, Blush, Bowing, Brittleness, Bubbles (voids), Burn Marks, Clear Spots, Cloudy Areas, Contamination, Cracking, Crazing, Delamination, Discoloration, Flash, Flow Lines, Gloss (low), Jetting, Knit Lines (welds), Non-Fill (short shots), Shrinkage (excessive), Sink Marks, Splay, and Warpage.
PLUS you get Doug's professional guidance regarding:
General Troubleshooting Concepts, Understanding The Molding Process, Venting The Mold, Understanding Materials, The Role Of The Operator, Recommended Melt Temperatures For Common Plastics, and Recommended Mold Temperatures for Common Materials.
AND you get a huge Glossary Of Terms!
Here are the 24 defects this Book thoroughly covers:
Black Specks, Blisters, Blush, Bowing, Brittleness, Bubbles (voids), Burn Marks, Clear Spots, Cloudy Areas, Contamination, Cracking, Crazing, Delamination, Discoloration, Flash, Flow Lines, Gloss (low), Jetting, Knit Lines (welds), Non-Fill (short shots), Shrinkage (excessive), Sink Marks, Splay, and Warpage.
PLUS you get Doug's professional guidance regarding:
General Troubleshooting Concepts, Understanding The Molding Process, Venting The Mold, Understanding Materials, The Role Of The Operator, Recommended Melt Temperatures For Common Plastics, and Recommended Mold Temperatures for Common Materials.
AND you get a huge Glossary Of Terms!
ONLY
$19.95!!!
plus s&h
$19.95!!!
plus s&h